Not Fit Modified Conversion Body Work!! #1 Before the installation starts. You need to check Fitting. Make test fitting of all pieces.
Hold them to the applying area and make sure every piece can line up and stay in place on your vehicle. #2 Please remove the transparent protection films on the fender flares kits before installation. #3 Double-sided tapes are pre-applied on the back of the fender flares kits. Slightly tear the red liner about 1 cm on the back of the double-side tapes from both side ends. Don't tear off the red liner completely before attaching! #4 Please wipe and clean the applying area on the vehicle before attaching all the kits. If there is any dust, dirt, mud or oil in the applying area, the double-sided tapes will easily fall off. #5 Attaching the fender flares.Adjust the position to make them in the best suited position. Once everything is lined up, pull out the red liner completely and slightly press the applying point.
To make the double-sided tapes completely attached to the body of the vehicle. #6 Screw in all the screw points to make the fender flares permanently attached on the vehicle. We do not work holidays in china. Our first priority is customer satisfactory. We will give you the best quality products and the best customer service.